How to fix 'System parameters destroyed' error on Omron Controller?
If the system parameters of your Omron Controller are destroyed, it could be due to memory data corruption from noise or the unit being turned off while writing to flash memory. To resolve this, download the system parameters again from the MC Support Software, write them to the flash memory, and then power cycle the unit.
How to fix setup error on Omron Controller?
To resolve a setup error on your Omron Controller, write the system parameters to the flash memory using the MC Support Software or Teaching Box, and then turn the power off and on.
What does ABS encoder error mean on Omron Controller?
The 'ABS encoder error' on your Omron Controller can be caused by a disconnected or broken encoder cable, a faulty encoder, or a faulty MC Unit. Check the encoder cable and try again.
How to troubleshoot ABS data error on Omron Controller?
The 'ABS data error' on your Omron Controller may be caused by a disconnected or broken encoder cable, a faulty encoder, or a faulty MC Unit. Check the encoder cable and try again.
What causes PV counter overflow error on Omron Controller?
A 'PV counter overflow' error on the Omron Controller can be caused by a faulty encoder, a disconnected or broken encoder cable, the axis moving beyond the counter’s range, or electrical noise. After correcting the problem, try executing the command again.
Why does my Omron Controller show 'Illegal intermediate code' error?
The 'Illegal intermediate code' error on your Omron Controller may occur if the memory data has been corrupted by noise or if the unit was turned off while data was being written to the flash memory. To solve this, download the program again, write it to the flash memory, and then turn the power off and on.
How do I fix a 'Program out of range' error on my Omron Controller?
The 'Program out of range' error on your Omron Controller can occur if the memory data has been corrupted by noise or if the unit was turned off while data was being written to the flash memory. To resolve this, download the program again, write it to the flash memory, and then turn the power off and on.
What causes 'Illegal G code' error on Omron Controller and how to fix it?
An 'Illegal G code' error on your Omron Controller can occur if the memory data has been corrupted by noise or if the unit was turned off while data was being written to the flash memory. To resolve this, download the program again, write it to the flash memory, and then turn the power off and on.
How to resolve 'Task 1 program destroyed' error on Omron Controller?
The 'Task 1 program destroyed' error on your Omron Controller indicates that the memory data might have been corrupted by noise or the unit was turned off while writing to flash memory. To fix this, delete all task 1 programs using the MC Support Software, which will automatically clear the error. Then, download the programs again and write them to the flash memory.
What to do if Omron Controller shows 'Wrong number of tasks' error?
The 'Wrong number of tasks' error on your Omron Controller occurs when the downloaded system parameters have a different number of tasks registered, or if memory data is corrupted by noise, or if the unit was turned off during writing to flash memory. You can either delete all programs using the MC Support Software or download system parameters with the number of tasks that matches the number registered in the program.
General| Model | C200H-MC221 |
|---|---|
| Type | Motion Control Unit |
| Compatible PLC Series | C200H |
| Number of Controlled Axes | 2 |
| Control Method | Position Control |
To Next Page
