To Next Page

To Previous Page

EtherNet/IP Connection Proce-

dures

This section describes the procedures for connecting the NJ/NX-series CPU Unit and

PMAC via EtherNet/IP to enable communications between them. The description as-

sumes that the NJ/NX-series CPU Unit and PMAC are set to factory default.

3-1

Work Flow .......................................................................................................3-2

3-2 NJ/NX-series CPU Unit Settings ................................................................... 3-3

3-2-1 Creating a New Project ................................................................................... 3-3

3-2-2 Setting the Network ......................................................................................... 3-3

3-2-3 Setting Variables ............................................................................................. 3-4

3-2-4 Creating and Checking the User Program ...................................................... 3-5

3-2-5 Setting EtherNet/IP (Tag Sets) ........................................................................ 3-9

3-2-6 Installing the EDS File ................................................................................... 3-10

3-2-7 Setting EtherNet/IP (Connections) .................................................................3-11

3-3 Preparations for Setting the PMAC ............................................................ 3-13

3-3-1 Creating a New Project ................................................................................. 3-13

3-3-2 Performing the Initial Settings for the PMAC................................................. 3-14

3-4 PMAC EtherNet/IP Settings .........................................................................3-16

3-4-1 Setting Connection 1 ..................................................................................... 3-16

3-4-2 Setting Connections 2 to 16 .......................................................................... 3-18

3-5 PMAC Settings.............................................................................................. 3-19

3-5-1 Creating a User Program .............................................................................. 3-19

3-5-2 Transferring Project Data and Checking the Operation................................. 3-19

3-1

CK3E/CK3M/CK5M Series EtherNet/IP Connection Guide (O903)

Omron CK5M-CPU 1 Series Connection Guide

Other manuals for Omron CK5M-CPU 1 Series