Omron CK5M-CPU 1 Series Connection Guide

4
Set the servo frequency.
In Servo Frequency, select 4 kHz, 2
kHz, or 1 kHz.
• This document gives an example of
setting this to 1 kHz.
5
Click the Accept
button.
6
If you change the servo frequency set-
ting, execute the save command from
the Power PMAC IDE T
erminal.
When the save command is completed,
"Save Completed" is displayed in the
Terminal.
7
Click the Communication Setup icon
in the toolbar to display the Communi-
cation Setup dialog box.
8
In the Communication Setup dialog
box, click the No Device button.
The T
erminal goes of
fline.
9
Start up the PMAC.
The set servo frequency is reflected.
10
Wait until the PMAC starts up, and click
the Communication Setup icon in the
toolbar to display the Communication
Setup dialog box.
In the Communication Setup dialog
box, click the Connect
button.
The T
erminal goes online.
3 EtherNet/IP Connection Procedures
3-15
CK3E/CK3M/CK5M Series EtherNet/IP Connection Guide (O903)
3-3 Preparations for Setting the PMAC
3
3-3-2 Performing the Initial Settings for the PMAC

Omron CK5M-CPU 1 Series Specifications

General

Brand	Omron
Model	CK5M-CPU 1 Series
Category	Controller
Language	English