6 Parameters
6 - 60
E5@C-T Digital Temperature Controllers User’s Manual (H185)
rtsm
Reset Operation
This parameter sets the control operation to perform when a reset has been performed.
• Stopping control: Control is stopped. If an MV is set for the MV at reset, it is output.
• Fixed SP operation: Control is executed for a fixed SP (FSP). The mode will always be
Fixed SP Mode.
* If fixed SP operation is set, control while resetting will be performed with the set value
of the Fixed SP parameter. Control will not stop.
z Related Sections
5-15 Program-related Functions (page 5-53)
p-on
Startup Operation
• This parameter sets the operating status when the power is turned ON.
• The specified operation is also used for software resets and when moving from Initial
Setting Level to Operation Level.
* If the PID ON/OFF parameter is set to ON/OFF, Manual Mode cannot be selected.
z Rated Sections
4-7 Setting Programs (page 4-27)
Function
Setting
Setting range Unit Default
stop: Stopping control
fsp: Fixed SP operation
--- stop: Stopping control
See
See
Function
Setting
Setting range Unit Default
cont: Continue
rst: Reset
run: Run
manu: Manual Mode*
--- cont: Continue
See
See
To Next Page
Loading...
