Omron E5CK-T User Manual

E5CK-T
E5CK-T
180
Quick Setup Instructions
The following procedure writes a simple program to Pattern 0.
Step number Target set point value Time (hours.minutes)
0 50 0.00
1 100 0.20
2 100 0.40
3 50 0.20
1. Press the Display Key to shift to the display for
the number of steps.
Pattern No.
Display key
ptrn
0
2. Press the Down Key and set the number of steps.
Four steps in this case
Down key
4
sĆno
Step number display
3. Press the Display Key to shift to the display for
the target value of step 0.
Step 0: Set target value
Target value (default setting: 0)
Display key
sp0
0
4. Set the target value to “50.”
Target value
Display key
50
sp0
Step number display
5. Press the Display Key to shift to the display for
the time of Step 0.
Time parameter for step 0
Step time (default setting: 0.00)
Display key
0.20
ti0
6. Press the Display Key again with the step time set
at 0 minutes, and the target value parameter for
Step 1 will be displayed.
Display key
0
sp1
Step number display
Target value
7. Press the UP Key to increment to “100.”
Display key
Step 1
100
sp1
Target value
8. In the same manner, set the time for Step 1, target
value for Step 2, time for Step 2, etc.
9. When the target value and time settings are com-
plete, press the Display Key.
Note: For more details about programming refer to the E5CK-T
User’s Manual, H090-E3-1.

Omron E5CK-T Specifications

General

Brand	Omron
Model	E5CK-T
Category	Controller
Language	English