Connection connector for FZ-VP£
Connection connector on the Sensor Controller
Pin No.
Signal name
Pin No.
Signal name
CN3 CN1 CN2
41 READY0 16 - READY0
42 DO0 - 17 DO0
43 DO2 - 19 DO2
44 DO4 - 21 DO4
45 DO6 - 23 DO6
46 DO8 - 25 DO8
47 DO10 - 27 DO10
48 DO12 - 29 DO12
49 DO14 - 31 DO14
50 DO15 - 32 DO15
Note: COMOUT is unified in 1 system with shorting PIN No.13, No.17, and No.25.
FH-VPX-FZL
l
Connection Structure (FH-VPX-FZL)
Parallel connector
(CN1/CN2)
FH controller
Connecting the FZ-VP and the FH-VPX-
* After the connection, lock it securely.
CN3
CN4
CN1
CN2
PLC, terminal blocks or
other products
FH-VPX-FZL
FZ-VP / FZ-VPX
Power supply used
in the FH controller:
Power supply S8VS
series (24 VDC)
Connector No. Connection destination Note
CN1 Connect to the parallel port CN1 on the Sensor Con-
troller
.
Even if you connect the CN1 and
CN2 reversely by mistake, it does
not work but will not be damaged.
CN2 Connect to the parallel port CN2 on the Sensor Con-
troller
.
CN3
Connect to the parallel I/O cable, FZ-VP£
-
6 I/O Interface
6-22
FH Series Vision System Hardware Setup Manual (Z366-E1)
To Next Page
Loading...
