Connector No. Connection destination Note
CN4 Connect to 24 V power source depending on the
NPN/PNP polarity as below table.
*1
• When the power source and
DIO are non-isolated and no
problem:
Possible to connect the same
power source for the FH series.
• When you want to isolate the
power source and DIO:
The power source for the FH
series cannot be used. Use an-
other power source.
Recommendations: S8VS ser-
ies, 24 VDC
*1. COM terminal polarity in NPN/PNP:
NPN PNP
COMIN +V -V
COMOUT -V +V
l
Cable (FH-VPX-FZL)
8
34
40
500
(35)
(20)
7
47.8
CN1
CN2
CN3
CN4
(200)
(Unit: mm)
6 I/O Interface
6-23
FH Series Vision System Hardware Setup Manual (Z366-E1)
6-1 Parallel Interface
6
6-1-4 Other (Parallel Converter Cable)
To Next Page
Loading...
