Omron HBP-1120

38
Immunity test
(1
WHVWOHYHO
Compliance
OHYHO
(OHFWURPDJQHWLFHQYLURQPHQW
guidance
Conducted RF
IEC 61000-4-6
Radiated RF
IEC 61000-4-3
3 Vrms
150 kHz to
80 MHz
80% AM (1 kHz)
3 V/m
80 MHz to
2.7 GHz
80% AM (1 kHz)
3 Vrms
3 V/m
Portable and mobile RF
communications equipment
should be used no closer to any
part of the HBP-1120, including
cables, than the recommended
separation distance calculated
from the equation applicable to
the frequency of the transmitter.
Recommend separation distance
d = 2
P
150 kHz - 80 MHz
d = 2
P
80 MHz - 2.7 GHz
where
P
is the maximum output
power rating of the transmitter
in watts (W) according to he
transmitter manufacturer and d
is the recommended separation
distance in meters (m).
Field strengths from fixed RF
transmitters as determined
by an electromagnetic site
survey*, should be less than
the compliance level in each
frequency range**.
Interference may occur in the
vicinity of equipment marked with
WKHIROORZLQJV\PERO
1RWH At 80 MHz and 800 MHz, the higher frequency range applies.
1RWH
These guidelines may not apply in all situations. Electromagnetic
SURSDJDWLRQLVDIIHFWHGE\DEVRUSWLRQDQGUHÀHFWLRQIURPVWUXFWXUHV
objects, and people.
)LHOGVWUHQJWKVIURP¿[HGWUDQVPLWWHUVVXFKDVEDVHVWDWLRQVIRUUDGLRFHOOXODU
cordless) telephones and land mobile radios, amateur radio, AM and FM radio
broadcast and TV broadcast cannot be predicted theoretically with accuracy.
7RDVVHVVWKHHOHFWURPDJQHWLFHQYLURQPHQWGXHWR¿[HG5)WUDQVPLWWHUV
DQHOHFWURPDJQHWLFVLWHVXUYH\VKRXOGEHFRQVLGHUHG,IWKHPHDVXUHG¿HOG
strength in the location in which the HBP-1120 is used exceeds the applicable
RF compliance level above, the HBP-1120 should be observed to verify normal
operation. If abnormal performance is observed, additional measures may be
necessary, such as reorienting or relocating the HBP-1120.
**
2YHUWKHIUHTXHQF\UDQJHN+]WR0+]¿HOGVWUHQJWKVVKRXOGEHOHVVWKDQ9P