72 LDî ±Platform Peripherals Guide 13732-000 Rev J
5.5 î ±MobilePlanner Configuration
NOTE: It may be simplest if you install one box at a time, and configure
that. This ensures that you know which box you are dealing with, so you
can assign the appropriate goal, for a call button, or appropriate map
data, for a door box. If you decide to install multiple call buttons or door
boxes before configuring them, refer to Identifying an Installed Call/Door
Box on page 73.
5.
Enable the Mobile Call-Button/GPIO software using SetNetGo.
Figure 5-23 Enabling the GPIO Software
a.
Access MobilePlanner > SetNetGo.
b.
Select Software > Manage Installed Software.
c.
Locate the package name Mobile Call-Button/GPIO Software from the listing.
Click the listing to expand the view.
d.
Click the Enable check box.
e.
Click OK to confirm that you wish to make the change.
To Next Page
Loading...
