Omron M2 Basic - Using the Memory Function

20
3.Using the Unit
3.5 Using the Memory Function
The unit automatically stores the last measurement values (blood
pressure and pulse rate) in the memory.
1. Press and hold the O/I START
button until the last
measurement value is
displayed along with the
memory symbol.
Important: If your systolic or diastolic
pressure is outside the
standard range, the
heartbeat symbol will blink
when the measurement
result is displayed. Refer
to 3.3.
2. Press the O/I START button to turn the unit off.
Note: If you forget to turn the unit off, it will automatically shut
itself off after five minutes.
HEM-7116-E(V)_EN_DE.book Page 20 Monday, June 18, 2012 4:21 PM