83
Appendix B
Settings from the Network Configurator
The following parameters can be set from the Network Configurator.
Note Network Configurator version 2.0 or higher is required to set the ED Router parameters.
Network Configurator
version 2.0 or hi
her
EtherNet/IP or DeviceNet
ED Route
Classification Setting Description Initial value Reference
ED Router
device settings
Displayed address Select whether the EtherNet/IP IP address
or the DeviceNet node address is to be dis-
played at the ED Router 7-segment display
under normal conditions.
DeviceNet node
address
2-5 ED Router
Settings
UDP port number Set a number from 1,024 to 65,535 as the
UDP port number to be used for device
access by UDP.
64,000
DeviceNet set-
tings
Baud rate for software
settings
Select 125 Kbit/s, 250 Kbit/s, or 500 Kbit/s. 125 Kbit/s 2-3 Connect-
ing to
DeviceNet.
Node address for soft-
ware settings
Set an address from 0 to 63. 63 (decimal)
Ethernet
(EtherNet/IP)
settings
IP address setting
method
Select either ìacquire from BOOTP or use
the next IP addressî as the IP address set-
ting method.
Use the next IP
address
2-4 Connect-
ing to Ethernet
(EtherNet/IP)
DNS usage Select to either use or not use DNS. Do not use DNS
IP address Specify the IP address for when use the
next IP addressî is selected as the IP
address setting method.
192.168.250.1
Network mask 255.255.255.0
Default gateway None (0.0.0.0)
Primary DNS server Specify the DNS server for when use DNS
is selected.
None (0.0.0.0)
Secondary DNS server None (0.0.0.0)
Domain name None (0000 hex)
A maximum of 48
ASCII characters
can be set.
LINK settings Select Auto, 10-Mbit/s half duplex, 10-Mbit/s
full duplex, 100-Mbit/s half duplex, or 100-
Mbit/s full duplex as the Ethernet (EtherNet/
IP) baud rate.
Auto
To Next Page
Loading...