27
Status Indicators Section 3-1
3-1-2 Seven-segment Display
This section describes the meanings of the 7-segment display.
Normal Status When no error has occurred and communications are enabled, the ED Router
DeviceNet node address is displayed as the initial status on the 7-segment
display.
• Display Example: When the Node Address Is 01
The rightmost byte of the EtherNet/IP IP address can be displayed by a set-
ting from the Network Configurator.
Error Status When an error occurs, the error code is displayed following Er. If multiple
errors occur, the error codes are displayed in order.
• Display Example: When the Error Codes Are d6 and E0
Displaying the EtherNet/IP IP Address and the DeviceNet Node Address
The EtherNet/IP IP address and the DeviceNet node address can be dis-
played on the 7-segment display by pressing the service switch for 1 s or
longer before releasing it.
• Display Example: EtherNet/IP IP Address
• Display Example: EtherNet/IP IP Address when BOOTP Is Set
• Display Example: DeviceNet Node Address
1000 ms Not lit
for
100 ms.
Not lit
for
100 ms.
Not lit
for
100 ms.
Not lit
for
300 ms.
1000 ms
(Error) (Error)
1000 ms
(Error code) (Error code)
To Next Page
Loading...