18
Connecting to Ethernet (EtherNet/IP) Section 2-4
2-4 Connecting to Ethernet (EtherNet/IP)
2-4-1 Setting the IP Address
This section describes methods for setting the IP address for the ED Router.
Method 1: The default IP address is 192.168.250.IP_address_switch_set
value.
The IP address is set with the rotary switches on the front of the
ED Router (IP ADR).
→ This method can be used to make a temporary or preliminary
connection to the Ethernet.
In this case, leave the TCP/IP Configuration setting at its
default value.
Method 2: Setting the TCP/IP Configuration from the Network Configura-
tor:
→ To set a particular local IP address, use the Network Configu-
rator.
The methods for setting the ED Router IP address are described below.
Method 1: Using the Default IP Address (192.168.250.IP_address_switch_set value)
The default IP address for the ED Router is
192.168.250.IP_address_switch_set value. The IP address switch is used to
set the IP address host ID.
IP address = 192.168.250.
IP_address_switch_set value
The host IC can be changed with the IP address switch. If 00 or FF is set, 01
will be used as the host ID.
The TCP/IP settings will be in the following default settings.
Method 2: Setting the TCP/IP Configuration from the Network Configurator
With this method, set the TCP/IP configuration, including the IP address, from
the Network Configurator.
Setting Operating status
IP address 192.168.250.IP_address_switch_set value
Subnet mask 255.255.255.0 (class C mask)
Default gateway None (IP routing disabled)
Preferred DNS server None
Alternate DNS server None
Host name None
Domain name None
Baud rate Auto-detect
To Next Page