31
Troubleshooting Section 3-2
Flash-
ing
red
--- Flash-
ing
red
F3 Invalid IP
address set-
ting
The IP address
is set to be
received from
the BOOTP
server, but the IP
address switch
is set for a value
other than 00 or
FF.
Operation contin-
ues, using the
value set by the IP
address switch.
0214 Check the IP address switch
setting and the configura-
tion, and make the settings
again.
Flash-
ing
red
--- --- E8 Device
parameter
error
An error
occurred in the
parameters
downloaded
from the Net-
work Configura-
tor.
Operation contin-
ues, using the
default setting.
021A Make the settings again from
the Network Configurator. If
the error persists after the
correct settings have been
made, replace the ED
Router.
Indicators/Display Error Cause ED Router
operation
Error
code
(hex)
Countermeasures
MS NS D NS E 7-seg-
ment
To Next Page
Loading...