7．Connection Procedure
7.5.2. Checking Data That Are Sent and Received
Confirm that the correct data are sent and received.
Always confirm safety at the destination node before you transfer a user
program, configuration data, setup data, device variables, or values in memory
used for CJ-series Units from the Sysmac Studio.
The devices or machines may perform unexpected operation regardless of the
operating mode of the CPU Unit.
1
Confirm that the online value of
DN00_Status_IN[6] is True (RUN
mode).
2
Confirm that MS LED indicator of
the Safety Network Controller is lit
green.
3
le
r and select Change Mode
- Idle.
Right-click the Safety Network
Control
41
To Next Page
Loading...
