Task Management
121
Turn bit On
This task is used for switching PLC coil or register bit to on state. The bit/coil should be a read-write coil.
This task is executed on coil or bit-addressed register only. User can select coil or bit-addressed register
from tag list.
By using this task user can set bit/coil to 1.
For this task default setting is shown under ‘Bit operations’. If user change this selection, task will be
changed.
Click ‘OK’ to add task in task list.
Turn bit Off
This task is used for switching PLC coil or register bit to off state. The bit/coil should be a read-write coil.
This task is executed on coil or bit-addressed register only. User can select coil or bit-addressed register
from tag list. By using this task user can set bit/coil to 0.
For this task default setting is shown under ‘Bit operations’. If user change this selection, task will be
changed. Click ‘OK’ to add task in task list.
To Next Page
Loading...
