Omron Powli BU50SW - 2 Installation and Connection; Precautions and Notes on Installation and Connection

BU50SW / BU75SW / BU100SW / BU150SW
5
1
2
3
4
5
6
7
8
9
10
Carry the unit considering its weight and balance, and place it on a
stable and robust base.
●
Dropping or toppling the unit may cause injury.
●
The weight of this unit is approximately: 13 kg (BU50SW/BU75SW)
15.5 kg (BU100SW)
16.5 kg (BU150SW)
●
If you drop the unit, stop using it and have it inspected and repaired.
For repair, contact us; ____
Keep plastic package bags out of reach of children.
●
Children may suffocate if they place their heads into plastic bags.
Make sure to connect the unit’s AC input plug to a commercial power
source with rated input voltage (100 to 120V AC) and 50/60Hz frequency.
●
Connecting to a wall outlet (commercial power) with a different voltage or frequency may
result in a fi re.
●
The unit may fail.
Do not connect devices such as dryers, which have a half-wave rectifi er
that allows only half-cycle AC power to fl ow through.
●
Overcurrent may damage the UPS.
Connect the unit to a wall outlet with the proper current capacity, as
follows: 8A or more (BU50SW), 10A or more (BU75SW), 12A or more
(BU100SW), or 16A or more (BU150SW).
●
Otherwise, the power cord may be heated.
●
When equipment with the maximum output capacity is connected, a maximum current of 8A
(BU50SW), 10A (BU75SW), 12A (BU100SW), or 16A (BU150SW) fl ows.
Provide secure grounding.
●
For a 3P wall outlet, directly connect the AC input plug of the unit to it. A failure or leak that
occurs when the unit is not properly grounded may result in electric shock.
●
When you use a 3P-2P conversion plug for AC input plug, be sure to perform grounding be-
fore connecting the AC input plug into a wall outlet (commercial power).
Do not disconnect the grounding before disconnecting the AC input plug from a wall outlet
(commercial power).
Do not disassemble, repair, or modify the unit.
●
Doing so may cause an electric shock or a fi re.
Do not install the unit in other than specifi ed orientations.
●
Dropping or toppling the unit may cause injury.
●
If you install the unit in an orientation other than specifi ed, the unit cannot be protected from
a battery fl uid leakage.
Do not use the unit where the maximum temperature exceeds 40
°
C.
●
The battery becomes weak rapidly, which may cause a fi re.
●
Doing so may cause a failure or malfunction of the unit.
Caution
(for installation and connection)
2-1 Precautions and notes on installation and connection
Installation and connection
22