Omron Powli BU50SW - When Performing Auto-Save Functions Using the Standard UPS Service in Windows Server 2003;XP;2000;NT

42
7. Using the UPS monitoring software and contact signal
When using in combination with the BUC26 cable (sold separately), the OS standard UPS service in
Windows Server 2003/XP/2000/NT can be used. When there is a power failure, the computer can be shut
down.
1. Connect the UPS to a computer.
Cable: Connection cable (BUC26), sold separately
Connector
Connect to
RS-232C
terminal
冷却ファン
INPUT
AC100V-120V入力
50/60Hz16A
AC入力
過電流保護
20A
Connect to RS-232C
port on PC
BU150SW
Connection cable (BUC26)
接地
信号カード
増設
OUTPUTAC100-12
0V50/60Hz1
ø
出力電力最大1.5kVA/1500W
バッテリ増設コネクタ
DC36V/40A
バッテリ増設信号コネクタ
RS232C
Connector
Connect to
contact signal
connector on UPS
2. Perform UPS service setup.
You need to make Windows settings in order to perform auto shutdown. There is no need to install soft-
ware.
<When using the Windows Server 2003/XP/2000 standard UPS service>
Start up the computer after connecting it with the UPS.
Perform "Log on to Windows" as the Administrator.
After logging on, follow the instructions below to set up the UPS service.
7-3
When performing auto-save functions using
the standard UPS service in Windows Server
2003/XP/2000/NT
<When using the Windows Server 2003/XP/2000 standard UPS service>
Start up the computer after connecting it with the UPS.
Perform "Log on to Windows" as the Administrator.
After logging on, follow the instructions below to set up the UPS service.