Omron Powli BU50SW - Page 56

BU50SW / BU75SW / BU100SW / BU150SW
43
1
2
3
4
5
6
7
8
9
10
Click
Click
Click
Click
Click
Click
3) Click the button on the right of the "Select manufacturer (S)" window, and select "General" from the
list.
Click on "Custom" in the "Select model (M)" window.
Click the button on the right of the "Port (P)" window, and select from the list the port that the UPS is
connected to. (In the example screen below, the UPS is connected to COM1.)
Click the "Next (N)" button.
●
How to set up UPS service (shut down Windows when low battery level is detected)
1) Double-click the "Power supply options" icon in "Control Panels".
2) Click the "UPS" tab in the "Power supply options" window.
Click the "Select (S)" button.
4) In the "UPS signal polarity" box, click on the boxes to the right of "Power supply failure/battery drive (P)"
and "Low battery (L)" signals to insert check marks.
Set the polarity for each signal to "Negative". Click the "End" button.
Click
Check
Check