Omron Powli BU50SW - 9 Extending the Backup Time; Connecting an Additional Battery Unit (BU100 SW;BU150 SW Only)

BU50SW / BU75SW / BU100SW / BU150SW
55
1
2
3
4
5
6
7
8
9
10
RS232C
信号カード
増設
冷却ファン
OUTPUTAC100-120V50/60Hz1ø
出力電力最大1kVA/700W
接地
INPUT
AC100V-120V
50/60Hz
12A
AC入力
過電流保護
15A
バッテリ
増設コネクタ
DC36V/20A
Battery connection
cable
Excess electromagnetic
protection switch
Cable clampCable clamp
ON OFF
RS232C
信号カード
増設
冷却ファン
OUTPUTAC100-120V50/60Hz1ø
出力電力最大1.5kVA/1500W
接地
INPUT
AC100V-120V入力
50/60Hz16A
AC入力
過電流保護
20A
バッテリ増設コネクタ
DC36V/40A
バッテリ増設信号コネクタ
Battery connection cableAdditional battery
signal connector
Additional battery
connector
Excess electromagnetic
protection switch
ON OFF
BU100SW BUM100S
You can extend the backup time by connecting an additional optional battery unit to the UPS.
When an additional battery unit is connected, the charging time is 24 hours.
For the BUM100S, the included battery connection cable is provided with cable clamps attached. Connect
the battery connection cable according to the instructions below. Cable clamps are not provided with the
BUM150S.
(1) Loosen the screws and remove the battery connector covers on the rear side of the unit and battery unit.
Use the removed screws to attach the cable clamps.
(2) Connect the battery connection cable to the battery connectors on the rear side of the unit and the bat-
tery unit. To simplify the operation, do not yet tighten the screws that hold the battery connection cable
on the cable clamp.
(3) Use screws to attach the cable clamps to the rear side of the unit and the battery unit (2 screws each).
(4) Tighten the screws that hold the battery connection cable on the cable clamps.
(5) Turn ON the overcurrent protection switch on the back of the battery unit.
(6) Connect the AC input plug of the unit to a wall outlet. The additional battery lamp on the unit's operation
panel turns ON.
UPS Additional battery unit
BU100SW BUM100S
BU150SW BUM150S
You can connect only one additional battery unit.
The explanation below is for connecting a BUM100S (for adding to BU100SW).
Use these instructions when adding a BUM150S to a BU150SW.
Some of the specifi cations are different.
See also For information on backup time, see the backup time table in ”5-2 Estimated backup
time”.
➛
Page 29
See also
9-1
Connecting an additional battery unit (BU100SW/
BU150SW only)
Extending the backup time
99
BU150SWBUM150S