Omron ZEN - 1-1 Outline

7 Programming Functions ZEN Programmable Logic Module
OMRON ELECTRONICS, S.A. Page 26
7.3.1. Settings in the Ladder Program
Weekly timer inputs are written in the ladder program edit screen. Settings are
carried out in the parameter settings screen.
No. of weekly timers @0 to @7
7.3.2. Settings in the Parameter Settings Screen
Note. When the flashing cursor is on the start day, press the left key followed
by the Up/Down keys to set the stop day. If the start day is not correctly set,
the timer will operate only according to the time set.
Start day Sun/Mon/Tues/Wed/Thurs/Fri/Sat
Day
Stop day Sun/Mon/Tues/Wed/Thurs/Fri/Sat/None
Start time 00:00 to 23:59Time
Stop time 00:00 to 23:59
A The parameters can be modified and monitoredMonitoring
enabled/disabled
D The parameters cannot be modified or monitored
Weekly timer address
Output to activate
No. of weekly timer
Start day
Stop day
Monitoring enabled/disabled
Start time
Stop time