19
Name the laser and set its X-axis length to 300mm and its Y-axis length to 200mm.
Choose a corner to use as the machineʼs origin point and click “Next”.
Choosing an origin diff erent from your design fi les may produce mirrored work or cause the laser to fi re off
your material, producing dangerous refl ections.
Check whether your setup is correct and then click “Finish”. The software should now work with your engraver.
Familiarize yourself with the software’s image design features and laser control settings before using it to operate
your device.
Other Programs
For other engraving software, follow its separate manual to confi gure the software to work with your new engraver
and contact customer service if you run into any trouble on the way.
To Next Page
Loading...
