8
2. Safety Information
2.1 Disclaimer
Your engraver may diff er somewhat from those shown in this manual due to options, updates, etc. Please contact us
if your engraving machine came with an outdated manual or if you have any other questions.
2.2 General Safety Instructions
• Your device should come with safety precaution labels such as those seen below:
If any labels are missing, illegible, or become damaged, they must be replaced.
• Use this laser engraving device only in accordance with all applicable local and national laws and regulations.
• Use this device only in accordance with this instruction manual. Ensure that this manual is included with this
device if it is ever given or sold to a third party.
• DO NOT operate continuously for more than 2 hours. Stop for at least 30 minutes between uses.
• DO NOT leave this device unattended during operation. Observe the device throughout
operation. If anything seems to be operating strangely, immediately cut off ALL power to the
machine and contact either our customer service or your dedicated repair service. Similarly,
ensure the device is FULLY turned off after each use.
• DO NOT allow minors, untrained personnel, or personnel suff ering from a physical or mental impairment that
would aff ect their ability to follow this manual to install, operate, maintain, or repair this device.
• Any untrained personnel who might be near the device while it is in operation MUST be informed that it is
dangerous and fully instructed on how to avoid injury during its use.
• Always keep a fi re extinguisher, water hose, or other fl ame retardant system nearby in case of accidents. Ensure
that the local fi re department's phone number is clearly displayed nearby. In the case of a fi re, cut electrical power
before dousing the fl ame. Familiarize yourself with the correct range for your extinguisher before use. Take care
not to use the extinguisher too close to the fl ame, as its high pressure can produce blowback.
To Next Page
Loading...
Need help?
General
