Onean X - Page 16

ONEAN X USER’S MANUAL
16
04
Use and ConfigUration of the eqUipment
d) reSet. 4 LedS bLinking
3. Once the controller has reached all 4 LEDs, all the
information will be stored and all LEDs will turn o.
If you do not want to change any of these parameters you don’t need
to do this process again, it will remain in the internal memory of the
controller.
4. To check the current status you can repeat step 1 but press on the drop
only one time instead of holding it pressed. The controller will show the
preferences for each category.
5. Always use the controller inside the controller wristband.
6. Always secure the wirstband before use.
7. In order to activate the jet, press on the drop with the index nger and
thumb.
8. The power will vary depending on the pressure placed on the drop.
4.2.2 . charging the controLLer
1. Connect the Qi charger through a USB.
2. Place the controller on the center of the Qi as shown in the drawing
below.
3. When charging, the green LED of the Wireless Controller will begin to
blink.
4. Once the controller is fully charged, the LED will turn o.
5. To check the status of the battery of the controller, please pick it up and
press on the drop to see the battery LED.
SYNC
BATTERY