Onean X - G Etting out of the Water; F Irst Use

ONEAN X USER’S MANUAL
19
05
Safety GuidelineS
5.3. FirSt uSe
5.3.1. Start uP
During the rst uses it is recommendable to use it on your knees.
1. Get on top of the board with the leash attached and the magnetic
key connected. You should place your knees on each side of the front
footstrap.
2. After being positioned, press on the drop to activate the jet. The power
will vary depending on the pressure being put on the drop.
3. Once you gain speed you can progressively stand on it.
Make sure not to accidentally press on the drop while getting on or o
the board.
5.3.2. turn
Before turning, make sure there is enough space to do so
and not interfere with the trajectory of any other vehicle.
Shift the weight towards the side where you intend to turn to ease the
movement. The more speed, the easier it will be to turn. The board turns like
a conventional board.
5.4. getting out oF the water
• Do not activate the jet outside of the water. The propulsion system is
not meant to be used outside of the water, this could signicantly damage
the jet.
• After a long use going full thrust, it´s recommendable to wait at least
one minute for the jet not to overheat.
• When the jet reaches high temperatures, an inner fan is automatically
activated for heat dissipation purposes. In order for this process to be
done appropriately, the jet must be in contact with the water.
• It is not recommendable to step on the battery surface. Although
it’s designed to hold weight, when stepping on it, the watertight seal
compresses facilitating water to get in.