Onean X - Quipment

ONEAN X USER’S MANUAL
21
06
Maintenance of the equipMent
6. Maintenance oF the equiPMent
6.1. board Maintenance
• It is recommended to rinse the jet with fresh water after every use.
When using in extreme saline environments, it´s recommendable to ash
the entire intake area with fresh water. This way the user will get rid of all
the excessive salt in the shaft and impeller.
• Do not leave the batteries connected. To disconnect them it´s necessary
to take them out of the board. The batteries power the board from the
moment they are inserted. Although the power consumption is very low,
it is not recommendable to leave them inside for long periods.
• Clean the stainless steel tube frequently. With every use, a small layer
of salt could build up over the surface. Given that the tube´s surface is in
charge of heat dissipation, it´s extremely important to have it clean for a
proper dissipation.
• It is not recommendable to place it upside down and never expose it to
direct sunlight over long periods of time.
• Periodically apply blue grease on the impeller and stator/nozzle.
• Between uses always keep the discharge connectors clean.
• Do not impact the turbine or rest the board over it.
6.2. battery Maintenance
• It is crucial to handle the batteries correctly while having it outside
of the board. In case of dropping it and due to its large weight, the
watertight seal could break. Do not use the batteries if they have been
dropped and contact the support team inmediately.
• For long lasting storage, it’s recommended to frequently recharge it (every
1 or 2 months) always keeping the capacity below 20%.
• In case of break, dint or any other form of apparent damage, do not
use the battery.
• It is recommendable to store the batteries in a dry place and not exposed
to direct sunlight.
• Do not submerge the batteries.
• Do not throw the batteries away. The batteries must be properly
destroyed at recycling facilities.
• Keep the male and female discharge connectors in good condition
always. Maintenance procedure: unscrew the female connectors from
the battery and the male connectors from the board. After that, clean
them with isopropyl alcohol and apply silicone grease (for electronic
contacts). Screw the female connectors to the battery and male
connectors to the board. The lack of maintenance or lack of tightness on
the connectors could do irreversible damage to the board.
• Unless in charging, protect always the battery´s connectors with
the plastic cover. The plastic covers avoid entering water inside the
connectors. In case you forget protecting the battery´s connectors, water
could damage the battery irreversibly.