Onean X - W Ireless C Ontroller

ONEAN X USER’S MANUAL
13
04
uSe and conFiguration oF the equiPMent
b) diSconnection
Avoid pulling from the cable, always pull
from the connector’s body.
c) iMPortant
Always supervise the charge, do not leave the batteries unattended while
charging.
• The batteries do not need to be fully discharged before charging. A
Lithium Ion battery doesn´t have memory effect. This means that
the maximum energy capacity won´t be aected if it´s charged after not
being fully discharged.
• Make sure that the batteries do not remain connected to the charger
after the charge has been completed.
• Always remember to close the battery rubber connector covers before
use.
• The temperature use for the batteries must always remain between 0 ºC
and 60 ºC (32 ºF y 140 ºF).
• Extreme temperatures will aect the batteries life, especially during
charge. Avoid charging the batteries while being exposed to direct sunlight
or extreme high or low temperatures. The charge is recommended to be
carried out with temperatures (between 10 ºC y 45 ºC / between 50 ºF y
113 ºF).
• Do not overdischarge the batteries. Do not continue riding once the
power starts to decrease and the LEDs on the top bar begin to blink, this
has been proven to decrease the battery’s capacity over time. This is an
extra energy resource which must be used only for emergencies.
4.2. wireLeSS controLLer
To activate the board you must press on the drop. The power of the Jet will
depend on the amount of pressure exerted on the drop.
4.2.1. controLLer conFiguration
Through the wireless controller you can set the maximum power for the Jet
and also adjust dierent proles.
In order to access the configuration menu, you must stick to the following
indications.
1. With the controller totally off (no LEDs ) place the drop over the logo.
SYNC BATTERY
Drop
Sync
Controller
battery
Board Battery
Power
Indicators
SYNC BATTERY
1
Connector’s
body
Cable