ONEAN X USER’S MANUAL
26
08
diagnosis system
SYNC BATTERY
TURBINE #1
TURBINE #2
ECU COMS
BATTERY
LEASH
SWITCH #1
SWITCH #2
8.1. diagnoSiS SySteM
The 2021 Onean X board comes with a Built-in Diagnosis System (DS). While pressing the Wireless Controller´s
drop with the board in use, the wireless controller will display any error concerning the turbines, ECU, battery,
leash and switch.
The error will display during 15 seconds in the display of the Wireless Controller.
a) turbine #1 FaiLure
The rst LED of the Wireless Controller will start blinking when Turbine #1 does not work. The board will not function. Contact with your nearest dealer or Onean.
b) turbine #2 FaiLure
The second LED of the Wireless Controller will start blinking when the board stops working after 2 seconds. This means failure in Turbine #2. Contact with your nearest
dealer or Onean.
c) ecu FaiLure
The third LED will start blinking when there is a problem with the ECU. The jetboard will not work. Contact with your nearest dealer or Onean.
d) battery FaiLure
The battery can not power the turbines. Check and tighten the battery´s female connectors and board´s male connectors. In case that the failure presists, contact your
nearest dealer or Onean.
e) LeaSh FaiLure
This means the leash magnet is not placed on the killswitch. You only have to position it on its place and continue riding.
F) Switch FaiLure
LED 1 and 4 means failure in the switch of the Turbine #1. LED 2 and 5 means failure in the switch of the Turbine #2. Contact with your nearest dealer or Onean.
To Next Page
Loading...
