OneTouch Verio Reflect - Remove the Old Batteries

139
10
Batteries
Replacing the batteries
Your OneTouch Verio Reflect
™
Meter uses 2x CR2032
lithium batteries. One battery powers the meter only
and the other powers the backlight. See page151 for
information on when to change the meter batteries.
If the meter does not turn on, or remains dim after
pressing a button, check the batteries.
Do Not change the batteries when connected to a PC.
IMPORTANT: Use only CR2032 lithium batteries with
your meter. Do Not use rechargeable batteries. Use of an
incorrect battery type or a used battery may result in your
meter providing fewer tests than normal.
WARNING: Certain batteries may cause leaking, which
can damage the meter or cause the batteries to lose power
sooner than normal. Replace leaking batteries immediately.
1. Remove the old batteries
Start with the meter turned off.
Remove the battery cover by
sliding it downward.
Pull up firmly on the plastic
ribbons. The plastic ribbon with
the
symbol is for the meter
battery, and the plastic ribbon
with the symbol is for the
backlight battery. Always change
both batteries at the same time.