140
10
Batteries
Replace the battery cover by
sliding it upwards onto the meter.
If the meter does not power
on after you have replaced the
batteries, check that the batteries
are correctly installed with the
"+" side up. If the meter still does
not power on, contact Customer
Care. Contact information for
Customer Care is listed at the end
of this Owner's Booklet.
2. Insert the new batteries
With the "+" side facing up
toward you, place each battery in
the compartment within the fold
of the plastic ribbon.
Push each battery in until it snaps
into the battery clasp.
To Next Page
Loading...
