Onicon F-5500 - Page 47

Programming
Display Screens
#1 & 2
Selections are:
DSP1L1 Display 1, Line 1
DSP1L2 Display 1, Line 2
DSP2L1 Display 2, Line 1
DSP2L2 Display 2, Line 2
To Program Display Screens #1 & 2:
From the Main Menu press DSP (F3) to select the display menu:
F1 F2 F3 F4
Press DSP (F1) key. The display will show:
F1 F2 F3 F4
These are the selections for the display #1 line #1.
Selections are:
Flo rate Flow rate
Total Total mass or volume
Elps Elapsed time
Temp Temperature
Alarm Error codes
When the selection is correct, press OK (F4) to accept. The display will then go
through the same process for all 4 lines of the 2 programmable displays (DSP1L1,
DSP1L2, DSP2L1 and DSP2L2).
After the last line of display 2 is accepted, the display will show the following menu:
F1 F2 F3 F4
This menu allows you to alternate between menu display 1 and 2 every few seconds.
Selections are: On or Off
Press OK (F4) to accept selection. Press EXIT (F4) repeatedly until “Normal Mode” is
seen briefly to exit the programming mode.
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-5500 Thermal Mass Flow Meter Manual 06/17 - 2030 / 107023 Page 47
Model F-5500
OPERATION
Operation: Programming
Programming
by Display
DISPLAY/PASSWORD
DSP PSW EXIT
DSP1L1 = Flo rate
NXT OK
ALTERNATE = Off
NXT OK