i
Password
Programming
Password
Units Settings
Password
There are two user level passwords, only Level 1 is programmable and gives access
to all the normal settings. The second password is used to allow access to calibration
factors and should normally never be changed unless advised by the ONICON service
department, or to set a new password in the event that the user forgets the Level 1
password.
Default Level 1 password is “1234”, and Level 2 password is “9111”. The Level 1
programmable password can be disabled by setting it to “0”.
From the Main Menu press DSP (F3) to select the display menu:
To Program the Password:
F1 F2 F3 F4
Press PSW (F3) key to select password.
F1 F2 F3 F4
This screen displays the current Level 1 password.
Press CHG (F1) key to change the password and enter new value.
Press OK (F4) to accept new data and exit programming by pressing EXIT (F4) key
repeatedly until out of the programming mode.
NOTE: Password can be number or letter characters up to 4 digits.
Units Settings Menu
This menu is used to set the units for flow, temperature, and pressure.
Reference temperature and reference pressure settings can be accessed also.
These values will be set at ONICON using information supplied by the customer. These
values can be changed to match a new application. The units settings are accessed
from the Main Menu.
To access the Unit Settings Menu:
11451 Belcher Road South, Largo, FL 33773 • USA • Tel +1 (727) 447-6140 • Fax +1 (727) 442-5699 • sales@onicon.com
F-5500 Thermal Mass Flow Meter Manual 06/17 - 2030 / 107023 Page 48
Model F-5500
OPERATION
Operation: Programming
DISPLAY/PASSWORD
DSP PSW EXIT
PASSWD = 1234
CHG OK
To Next Page
Loading...