Onkyo HT-RC160 - FM;AM Frequency Step Setup

43
First Time Setup—Continued
For FM/AM tuning to work properly, you must specify
the FM/AM frequency step used in your area. Note that
when this setting is changed, all radio presets are
deleted.
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
FM/AM Frequency Step Setup
1
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w] but-
tons to select “7. Hardware
Setup”, and then press [ENTER].
The “Hardware Setup” menu appears.
3
Use the Up and Down [q]/[w] but-
tons to select “2. Tuner”, and
then press [ENTER].
The “Tuner” menu appears.
4
Use the Left and Right [e]/[r]
buttons to select:
200kHz/10kHz:
Select if 200 kHz/10 kHz steps are
used in your area.
50kHz/9kHz:
Select if 50 kHz/9 kHz steps are
used in your area.
7. Hardware Setup
1. Remote ID
2. Tuner
3. HDMI
7–2. Tuner
FM/AM Frequency Step 200kHz/10kHz
5
Press the [SETUP] button.
The setup menu closes.