83
Zone 2—Continued
If you’ve connected your Zone 2 speakers to the AV
receiver, as explained in “Connecting Your Zone 2
Speakers Directly to the AV receiver” on page 82, you
must set the “Powered Zone 2” setting to “Act” (Acti-
vated).
Notes:
• When “Act” is selected and Zone 2 turned on, the
Zone 2 speakers connected to the ZONE 2 L/R
speaker terminals output sound, but the surround back
or front high speakers connected to the SURR BACK/
FRONT HIGH L/R speaker terminals do not. When
“Act” is selected and Zone 2 turned off, the surround
back or front high speakers output sound as normal.
• When the “Powered Zone 2” setting is set to “Act”
and the input selector of Zone 2 is selected, power
consumption on standby mode slightly increases.
• Powered Zone 2 cannot be used if “Speaker Type” is
set to “Bi-Amp” (see page 42).
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Setting the Powered Zone 2
1
Press the [RECEIVER] button
followed by the [SETUP] button.
The main menu appears onscreen.
If the main menu doesn’t appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [q]/[w]
buttons to select “2. Speaker
Setup”, and then press [ENTER].
The “Speaker Setup” menu appears.
3
Use the Up and Down [q]/[w]
buttons to select “1. Speaker
Settings”, and then press
[ENTER].
The “Speaker Settings” menu appears.
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
4
Use the Up and Down [q]/[w]
buttons to select “Powered
Zone 2”, and use the Left and
Right [e]/[r] buttons to select:
Not Act:
ZONE 2 L/R speaker terminals not
activated (Powered Zone 2 dis-
abled).
Act:
ZONE 2 L/R speaker terminals
activated (Powered Zone 2
enabled).
5
Press the [SETUP] button.
The setup menu closes.
To Next Page
Loading...
