86
Entering Characters
■
Naming the preset stations
You can name the preset stations using up to 8
characters.
•You can use the following characters:
_ represents a space.
Only the remote controller buttons are used in this procedure.
First select the preset station you wish to name.
Note
•You can’t name a preset that’s tuned to an RDS station broadcasting PS (Program Service
Name) information. (See page 82 for more information on RDS stations.)
Only European models support RDS, and only in areas where RDS is used.
TV MUTINGTV MUTING
TV
POWER
TV
POWER
TV
INPUT
TV
INPUT
TV VOL
+
TV VOL
+
TV VOL
-
TV VOL
-
TV CH
-
TV CH
-
TV CH
+
TV CH
+
VOLUME
TOP MENU MENU
RETURN
DVD
SETUP
REPEAT A
-
B STEP/
SLOW
SLEEP
MUTING
DIMMER DISPLAY CLOCK
1, 4
2
3
_ A B C D E F G H I J K L
M N O P Q R S T U V W X Y
Z " ' & ( ) [ ] * + , - / = ?
0 1 2 3 4 5 6 7 8 9
DISPLAY
DISPLAY
Press and hold down DISPLAY (for
three seconds) to display “NAME IN.”
Select a character.
Press to select a character.
Press ENTER to enter the character.
Repeat Steps 2 and 3 to enter up to eight char-
acters.
Tip
• If you wish to leave the name blank, press
ENTER while no character is displayed.
Press and hold down DISPLAY (for
three seconds) to store the name.
When you enter eight characters, the naming
operation is automatically complete.
/
1
2
3
4
L-DR7_E.book Page 86 Tuesday, December 24, 2002 3:10 PM
To Next Page
Loading...
Need help?
General
