Onkyo TX-NR3030(B)

TX-NR1030/3030/ PR-SC5530/ DTR-60.6/70.6/ DHC-80.6
DEBUG MODE-1
AUDIO DEBUG MODE-1/4
To set in Debug mode
1. Press twice the ON/STANDBY key while pressing the DISPLAY key.
The version number of microprocessor is displayed
only for 3 seconds.
The version number of DSP is displayed
only for 3 seconds.
AUDIO DEBUG MODE (Display mode of the audio information)
The operations of DSP and DIR etc are able to checked by the information displayed on FL in this debug mode.
This information will help to analysing digital audio no sound trouble.
Audio dubug mode
Step-1
Exit
e.g.
Main:
1.01/13515AE8
2. Press + (TONE) button while the version number of microprocessor is displayed.
3. Press DISPLAY button while the version number of DSP is displayed.
DSP 1st/NET:
1.07/13514AEA
e.g.
0A0002: :00
ANA:o:NON: :
4. Press DISPLAY button.
SP00F
*
00F00409
48 48256STB
2:o:PCM :PCM
00:x:F:OFF
1:ANA 048k048k
2/0.0: 2.0:3/4
9. Press DISPLAY button.
8. Press DISPLAY button.
6. Press DISPLAY button.
5. Press DISPLAY button.
11. Press DISPLAY button.
12. Press DISPLAY button.
10. Press DISPLAY button.
7. Press DISPLAY button.
13. Press DISPLAY button.
LW : 0 0
RW : 0 0
LB : 0 0
RB : 0 0
LH : 0 0
RH : 0 0
LS : 0 0
RS : 0 0
C : 0 0
L : 0 0
R : 0 0
SW : 0 0
SW2 : 0 0
Step-2
Step-11
Step-10
Step-9
Step-8
Step-7
Step-6
Step-5
Step-4
Step-3
14. Press DISPLAY button.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.
e.g.