Onkyo TX-RZ3100 - Speaker and Audio Setup

"AUDIO1"to"AUDIO6":AssignadesiredAUDIOINjacktotheCDbutton.
TV
DefaultValue:AUDIO6
"AUDIO1"to"AUDIO6":AssignadesiredAUDIOINjacktotheTVbutton.
PHONO
DefaultValue:PHONO
Thesettingcannotbechanged.
2.Speaker
Youcanmakechangestotheconnectionenvironmentofthespeakersand
changethevolumelevel.SettingsareautomaticallyconfiguredifyouuseAccuEQ
RoomCalibration.Thissettingcannotbeselectedifheadphonesareconnectedor
audioisoutputfromthespeakersoftheTV.
1.Configuration
SpeakerChannels
DefaultValue:7.1.4ch
Select"2.1ch","3.1ch","4.1ch","5.1ch","6.1ch","7.1ch","2.1.2ch",
"3.1.2ch","4.1.2ch","5.1.2ch","6.1.2ch","7.1.2ch","4.1.4ch","5.1.4ch",
"6.1.4ch",or"7.1.4ch"tosuitthenumberofspeakerchannelsconnected.
Subwoofer
DefaultValue:2ch
SetthePREOUTSUBWOOFERjackswhichoutputaudiosignals.
"1ch":OnlythePREOUTSUBWOOFER1jacksoutputaudiosignals.
"2ch":BoththePREOUTSUBWOOFER1jacksandthePREOUT
SUBWOOFER2jacksoutputaudiosignals.
"No":NeitherthePREOUTSUBWOOFER1jacksnorthePREOUT
SUBWOOFER2jacksoutputaudiosignals.
Height1Speaker
DefaultValue:TopFront
SetthespeakertypeifheightspeakersareconnectedtotheHEIGHT1
terminals.Select"FrontHigh","TopFront","TopMiddle","TopRear","Rear
High","DolbySpeaker(Front)","DolbySpeaker(Surr)",or"DolbySpeaker
(Back)"accordingtothetypeandlayoutoftheconnectedspeakers.
Thissettingcannotbeselectedunderanyoffollowingconditions.Setthe
heightspeakerstypeto"Height2Speaker".
– "BiAmp"issetto"Yes"
– "ZoneSpeaker"issetto"Zone2/Zone3"
Whentwosetsofheightspeakersarebeingused,"TopRear","Rear
High","DolbySpeaker(Surr)",and"DolbySpeaker(Back)"cannotbe
selected