Onkyo TX-RZ3100 - Connecting a Power Amplifier

ConnectingaPowerAmplifier
Youcanconnectapoweramplifiertotheunitandusetheunitasapreamplifierin
ordertoproducealargevolumethatcannotbeoutputwiththeunitonly.Connect
thespeakerstothepoweramplifier.Fordetails,refertothepoweramplifier's
instructionmanual.
Connections
1. ConnectasbelowusingthePREOUTterminals.
Settosuitthenumberofspeakerchannelsconnected.
– Press ontheremotecontrollertodisplaytheSetupmenu.Select"2.
Speaker""Configuration""SpeakerChannels"inorderwiththe
cursors,andsetthenumberofspeakerchannels.
Youcanreducepowerconsumptionbyturningoffthepowerofthe
SPEAKERSterminalsyouarenotusingonthisunit.Makethesettingin"7.
Miscellaneous""PreampMode"intheSetupmenu.
Settings