Onkyo TX-RZ3100 - Page 18

– Whentwosetsofheightspeakersarebeingused
– When"ZoneSpeaker"issetto"Zone2/Zone3"
– WhenheightspeakersandZONEspeakersarebeingusedatthe
sametime.
2.Crossover
IfyouareusingTHXcertifiedspeakers,werecommendthefollowingsettings:
– Setavalue"80Hz(THX)"inCrossoverfrequency.
– Setavalue"80Hz"in"LPFofLFE".
– Setavalue"Off"in"DoubleBass".
Front
DefaultValue:80Hz(THX)
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostartoutputting
frequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
If"Configuration""Subwoofer"issetto"No","Front"willbefixedto"Full
Band"andthelowpitchedrangeoftheotherchannelswillbeoutputfrom
thefrontspeakers.Refertotheinstructionmanualofyourspeakersto
makethesetting.
Center
DefaultValue:80Hz(THX)
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostartoutputting
frequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
"FullBand"canbeselectedonlywhen"Front"issetto"FullBand".
Ifanitemcannotbeselectedeventhoughconnectioniscorrect,check
thatthesettingsin"Configuration""SpeakerChannels"matchesthe
numberofconnectedchannels.
Height1
DefaultValue:80Hz(THX)
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostartoutputting
frequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.
"FullBand"canbeselectedonlywhen"Front"issetto"FullBand".
Ifanitemcannotbeselectedeventhoughconnectioniscorrect,check
thatthesettingsin"Configuration""SpeakerChannels"matchesthe
numberofconnectedchannels.
Height2
DefaultValue:80Hz(THX)
Selectthecrossoverfrequencyfrom"40Hz"to"200Hz"tostartoutputting
frequenciesforeachchannel.
"FullBand":Fullbandwillbeoutput.