Onkyo TX-RZ3100 - Page 39

AMNoiseCutMode
DefaultValue:1
Youcanimprovereceptionsensitivitybychangingthismodeifyouare
findingAMbroadcastsdifficulttohear.Select"1"or"2".
2.RemoteID
RemoteID
DefaultValue:1
SelectanIDfortheunit'sremotecontrollerfrom"1","2",and"3"toprevent
interferencebetweentheunitandotherONKYOcomponentsthatare
installedinthesameroom.AfterchangingtheIDonthemainunit,change
theIDontheremotecontrolleraccordinglywiththefollowingprocedure.
WhileholdingdownMODE,pressthefollowingnumericbuttonsforabout3
seconds.
TochangetheremotecontrollerIDto"1":1
(MAINbuttonflashesonce.)
TochangetheremotecontrollerIDto"2":2
(MAINbuttonflashestwice.)
TochangetheremotecontrollerIDto"3":3
(MAINbuttonflashesthreetimes.)
3.PreampMode
IfspeakersareconnectedtothePREOUTjacksonthisunitviaapoweramplifier,
youcanreducethepowerconsumedbythisunitbyturningoffthepowersupplied
totheSPEAKERSterminalsyouarenotusingonthisunit.
PreampMode
DefaultValue:No
SelecttheSPEAKERSterminalswhosepoweryouwanttoturnoff.
"No":PowerissuppliedtoallSPEAKERSterminals.Selectwhenapower
amplifierisnotconnected.
"Front":TurnsoffthepowerfortheSPEAKERSterminalsforthefront
speakers.
"Front+Center":TurnsoffthepowerfortheSPEAKERSterminalsforthe
frontspeakersandcenterspeaker.
"All":TurnsoffthepowerforallSPEAKERSterminals.Selectwhenthisunit
istobeusedasthepreamplifier.
Thissettingcannotbeselectedwhenbiampconnectionisusedfor
speakers.
4.FirmwareUpdate
UpdateNotice
DefaultValue:Enable