Onkyo TX-RZ3100 - Page 42

1. Placethesuppliedspeakersetupmicrophoneinthelisteningposition,and
connecttotheSETUPMICjackonthemainunit.
Whenputtingthespeakersetupmicrophoneonatripod,refertotheillustration
whenputtingitinplace.
TocancelAccuEQRoomCalibrationpartwaythrough,disconnectthe
speakersetupmicrophone.
2. Selecttheconnectedspeakerconfiguration.
Theimageonthescreenchangesasyouchoosethenumberofchannelsin
"SpeakerChannels",sorefertoitwhenperformingthesettings.
Alsousethisscreentoselectwhetheryouhaveconnectedasubwooferandto
selectthetypeofheightspeaker,etc.
Ifyouhaveconnectedasubwoofer,checkthepowerandvolumeofthe
subwoofer.Setthesubwoofervolumetomorethanhalfway.
3. Testtonesareemittedbythespeakers,andfirstlytheunitdetectsthespeakers
connectedandthenoiseintheenvironment.
4. Aftertheresultsoftheabovemeasurementsaredisplayed,select"Next",
pressENTERontheremotecontroller,andthetesttonesareemittedagain,
andtheunitautomaticallymakessettingssuchastheoptimumvolumelevel
andthecrossoverfrequency.
5. Selectwhethertoenableordisabletheequalizerfunctionthatcorrectsfor
distortioncausedbytheacousticenvironmentoftheroom.