Onkyo TX-SR303E

32
First Time Setup—Continued
This section explains how to specify which speakers are
connected and their sizes.
For speakers with a cone diameter
larger than 6-1/2 inches (16 cm),
specify Large. For those with a
smaller diameter, specify Small.
Speaker Configuration
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
Cone diameter
MUTING
MENUTOP MENU
SP A / B
SETUPRETURN
RANDOM
SUBTITLE
PLAY MODE
AUDIO REPEAT
RC
-
605S
--
/
---
TAPE/AMP
ON STANDBY
DIMMER SLEEP
INPUT SELECTOR
REMOTE MODE
V1 V2 V3
C DTAPE TUNER
DVD
MULTI CH
LISTENING MODE
DISPLAY
TEST TONE CH SEL
SURROUND STEREO
CINE FLTR
LEVEL
+
LEVEL
-
L NIGHT
VOL
CDR
MD
DVD
RECEIVER
C D
+
10
0
CLR
123
456
789
ENTER
CH
DISC
RETURN
1
1, 9
2–8
2
Use the Up and Down [ ]/[ ]
buttons to select “1. Speaker
Config,” and then press the
[ENTER] button.
3
While the Subwoofer setting is
selected, use the Left and Right
[ ]/[ ] buttons to select Yes or
No.
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4
Use the Down [ ] button to
select “Front,” and then use the
Left and Right [ ]/[ ] buttons to
select Small or Large.
Small: Select if the front speakers are
small.
Large: Select if the front speakers are
large.
Note:
• If the Subwoofer setting in step 3 is
set to No, this setting is fixed at Large
and does not appear.
5
Use the Down [ ] button to
select “Center,” and then use the
Left and Right [ ]/[ ] buttons to
select Small, Large, or None.
Small: Select if the center speaker is
small.
Large: Select if the center speaker is
large.
None: Select if no center speaker is
connected.
Note:
• If the Front setting in step 4 is set to
Small, the Large option cannot be
selected.