Onkyo TX-SV525

Remote control
REMOTE CONTROL RC2879 FRI
(> Sleep button (SLEEP) (Remote control transmitter only)
Press to set the power off timer. The sleep timer is a function
which turns off the power to the system from the time it is set.
When this button is pressed, “90 MIN” is displayed for 5 sec-
onds, and the power goes off 90 minutes later. Each time the
button is pressed during 5 seconds, the timer setting changes,
by 10 minute intervals, such as 80, 70, 60 .... While the sleep
timer is operating, the indicator is lit. If the sleep but-
ton is pressed during this time, the amount of time remaining
on the sleep timer is displayed, and if the button is pressed dur-
ing that display, 10 minutes will be subtracted from that time. If
the button is pressed when the panel display shows 10 minutes
or less, the sleep timer is cancelled, and the power is not turned
off.
(2) Power button (POWER) [18, 19]
(3) Input selector buttons [18, 30]
(TAPE-1, TUNER, PHONO, CD, TAPE-2, VIDEO-1, VIDEO-
2, VIDEO-3)
When the TUNER button is pressed, the station which was
received previously ts recalled. Selection of AM or FM should
be done on the main unit.
(4) Tape oeration buttons (DECK-A, DECK-B)
These buttons control ONKYO double cassette tape decks that
can be remote controlled. Use the DECK-B buttons to control
single cassette tape decks with the I mark.
@/11 : When this is pressed, the recording stand-by mode is
entered.
<a: The tape plays, moving from right to left, or, in the
recording stand-by mode, recording begins.
a : Interrupts all operations.
wm : The tape plays, moving from left to right, or, in the
recording stand-by mode, recording begins.
¢< =: ~ Fast forward from right to left.
pe = Fast forward from left to right.
(5) CD operation buttons (CD)
These buttons are used to operate an ONKYO CD player with
the “QI mark.
wm : Press this button to play the CD player.
LT | : Press this button to pause the CD play back. To resume
disc play, press the m= button.
DISC : Press to use for sequential selection of discs in the
order they were loaded on the CD changer.
a : Press this button to stop the CD player.
Iq =: Press this button to go back to the beginning of the cur-
rent track and again to skip back to the previous track.
Pri : Press this button to skip to the next track.
(6) Test tone button (TEST) [26]
(7) Surround mode button (SURROUND MODE) [25, 26]
Delay time button (DELAY TIME) [25, 26]
(9) Speaker selector buttons
(SPEAKERS MAIN/REMOTE) [18, 19, 30]
Multi source button (MULT! SOURCE) [30]
1) Multi source level up/down buttons [30]
(LEVEL «/¥v)
(2) Group selector button (GROUP) [21]
(3) Preset memory UP/DOWN buttons (PRESET 4/¥)
[21]
Audio muting button (MUTING)
This button temporarily switches off the sound from the speak-
ers or headphone by operating this unit audio muting circuits.
The audio muting indicator “AUDIO MUTING” will flash.
Pressing the button again or using the POWER button to turn
the power on will turn off the audio muting.
@ Pressing this button does not mute the sound of the multi
source. Press the SPEAKERS REMOTE button to mute the
sound of the multi source.
(5) Volume buttons (VOLUME 4/¥) [18, 19]
Center level up/down buttons (CENTER LEVEL a/v)
Rear level up/down buttons (REAR LEVEL 4/W ) [26]
1/