Onkyo TX-SV525

Precautions
1. Warranty Card
The serial number ts written on the rear panel of this unit. Copy the
serial number and model number onto your warranty card and
keep it in a safe place.
2. Recording Copyright
Recording of copyrighted material for other than personal use is
illegal without permission of the copyright holder.
3. AC Fuse
The fuse 1s located inside the chassis and is not user-serviceable.
If power does not come on, contact your Onkyo authorized service
station.
4. Care
From time to time you should wipe the front and rear panels and
the cabinet with a soft cloth. For heavier dirt, dampen a soft cloth
in a weak solution of mild detergent and water, wring it out dry,
and wipe off the dirt. Following this. dry immediately with a clean
cloth. Do not use rough material, thinners, alcohol or other chemi-
cal solvents or cloths since these could damage the finish or
remove the panel lettering.
5. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
@ Some models are designed for use only with the power supply
voltage of the region where they are sold.
European and Australian models: AC 230V, 50Hz
U.S.A. and Canadian models: AC 120V, 60Hz
Worldwide model: AC 220V/120¥V switchable,
50/60Hz
e Voltage Selector (Rear Panel)
Worldwide models are equipped with a voltage selector to con-
form to local power supplies. Be sure to set this switch to
match the voltage of the power supply in your area before plug-
ging in the unit. Models without a voltage selector can only be
used in areas where the power supply 1s the same as that of the
unit.
Memory Preservation
Supplied accessories
Zz
ESE
sag
1 Remote control 1 Remote control cable
2 Batteries
(size AA, R6, or UM-3)
1 AM loop antenna 1 T-shaped FM antenna
(Worldwide models only)
1 75/300 ohm
antenna adaptor
1 CV plug (Shape may vary
according to the area
where purchased.)
This unit does not require memory preservation batteries. A built-in
memory power back-up system preserves the contents of the mem-
ory during power failures and even when the unit is unplugged. The
unit must be plugged in order to charge the back-up system.
The memory preservation period after the unit has been unplugged
varies depending on climate and placement of the unit. On the aver-
age, Memory contents are protected over a period of a few weeks
after the last time the unit has been unplugged. This period is
shorter when the unit ts exposed to a highly humid climate.
For USA and Canada
@ Manufactured under license from Dolby Laboratories
Licensing Corporation.
Additionally licensed under Canadian number 1[,037,877.
“Dolby”, “Pro Logic”, and the double-D symbol are trade-
marks of Dolby Laboratories Licensing Corporation.
e@ Replacement and mounting of an AC plug on the power supply
cord of this unit should be performed only by qualified service
personnel.
@ IMPORTANT: The wires in the mains lead are coloured in
accordance with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this apparatus may
not correspond with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wire which 1s coloured blue must be connected to the terminal
which is marked with the letter N or coloured black.
The wire which ts coloured brown must be connected to the termi-
nal which is marked with the letter L or coloured red.