Onkyo TX-SV525

Before using this unit
(Worldwide models only)
1. Determine the proper voltage for your area: 220V or [20V.
2. If the preset voltage is not correct for your area, insert a screw-
driver into the groove in the switch. Slide the switch all the way
to the right (120V) or to the left (220V), whichever 1s appropri-
ate.
VOLTAGE SELECTOR
220V0L 120V,
eoo0oceo0o0o0o0o0 ky CoO
eooococooo0so
Worldwide models are equipped with a switch that controls the
AM (9kHz/10kHz) band tuning steps.
Please set this switch to match the tuning step frequency in your
STEP area.
QkHz 1OkHz ULS.A.: AM 10kHz
Other areas: AM 9kHz
AM FREQ.
Insert the batteries into the remote control according to the
illustration. The following information will help you get optimal use from the
remote control.
@ Place this unit away from direct bright light, which can prevent
proper operation of the remote control.
e@ Make sure audio rack doors do not have tinted glass. If this unit
is placed behind such a door, this may prevent proper remote
control operation.
e Using other remote controls in the same room as this unit's
remote control may cause interference.
approx. 5m
Average battery life is about one year, depending upon the fre-
quency of use and the environment (temperature and humidity) in
which the remote contro] is used. Only use batteries of the kind
specified in the table below.
Warning
@ Do not leave an expired battery in the case — it may leak or dam-
age the remote control.
e Do not use nickel cadmium (rechargeable) batteries.
e Replace both batteries at once; do not use one old battery and
one new battery.