Onkyo TX-SV525

MEMORY
O MEMORY
(TX-SV525R) :
PRESET SCAN
{TX-SV525)
: Remote control
Remote contro! PRESET
TUNER
GROUP
MEMORY FM MUTE/MODE
O O
LcLeAR —
Since ten AM or FM stations can be stored in each group (A, B or
C), a total of 30 stations can be stored in the memory.
Programming radio station
1. Select the frequency that you want to store in the memory.
(See page 20 Tuning the radio)
2. Press the MEMORY button.
The MEMORY indicator will light for 8 seconds.
3. While the MEMORY indicator lights, press the GROUP
button to choose the desired group.
The group shown on the display changes in the following order
each time the button is pressed: A > B> C >A.
4. Select the desired memory number using the number but-
tons.
Press button 0/10 when choosing memory number 10.
NOTE (TX-SV525R only):
If the FM station received is an RDS station with a PS (Program
Service Name), the frequency display will change to the PS dis-
play. If there is no PS, the frequency display will not change.
(Refer to page 22 — 24 for the RDS function)
Main unit
.. Press the GROUP button to select the desired group.
z-&., Input the memory number you wish to receive by using
the number buttons.
zt. Press the SCAN (or PRESET SCAN) button.
Each station stored in the group chosen in step | will be received
for 5 seconds (for each station).
When the station that you want is found, press the SCAN (or PRE-
SET SCAN) button again and scanning will stop.
Remote control
[1] Press the GROUP button and choose the group.
Press the PRESET ( A or V ) button.
After the last number of GROUP C is reached, scanning will
restart at GROUP A.
1. Select the station that you want to cancel as explained in the
previous section.
2. Press the FM MUTE/MODE button while holding down
the MEMORY button.
ot .
--" will be shown on the display.
21