Onkyo TX-SV525

Entering station names (TX-SV525R only)
Characters can be entered during reception of an FM or AM broadcast station.
This function enables you to memorize a maximum of 8 characters consisting of alphabetics, some symbols and numbers, for instance, repre-
senting broadcasting names, for each preset station.
If you attempt to enter characters while receiving an FM broadcast RDS station, “RDS...PS” is displayed and characters cannot be entered.
Characters which can be input
ABCDEFGHIJKLMNOPQRSTUVW
XY¥Z1234567890-uUx/
Note: — indicates a space.
To name 1CH of GROUP B as “ONKYO", for example, operate
as follows. (Example: FM broadcast at 89.50 MHz has been mem-
orized into [CH of GROUP B).
1. Press the GROUP and number button.
The memorized broadcast station is received.
2. Press the CHARACTER button.
The frequency in the display goes off and “_” flashes.
3. To enter O from “ONKYO”, press the SMNO button.
Pressing the button each time changes the character from 5 to
CT M, N, and O, one at a time. Select O.
e “_” will move to the next character. (If you do not press the
number button for one second, “_” will automatically move to
the next position.)
e@ When you want to delete a character, press the DIRECT TUN-
ING button. The character ts deleted, and the characters on the
right move to the left by one space.
4. Repeat step 3.
To enter N from “ONKYO”, press the 5MNO button and select
N.
To enter K from “ONKYO” press the 4JKL button and select
K.
5. Press the CHARACTER button.
If you have not pressed a button for 16 seconds, the operation
will complete automatically.
be 499
CHARACTER
lL. Press the CHARACTER button.
2. While pressing the MEMORY button, press the FM MUTE/
MODE button.
All the characters entered for this station will be cleared.
ESS
chaacten ? .. Press GROUP buttons to recall the desired preset number.
(ee PRP BEEP 2. Press the CHARACTER button.
: The first character and “_” flashes alternately.
*, Press the < DOWN TUNING UP » button and move ‘*_” to
the character you want to change.
“_” moves to the right when pressing the UP » button and
moves to the left when pressing the < DOWN button.
4. Enter the desired character.
The previous character is replaced with a new character.
5. Press the CHARACTER button.
CHARACTER
—s