Onkyo TX-SV525

Recording a source
TAPE-2
MON'TOR
VCR recording
1. Press the input selector button of the source to be recorded.
(other than TAPE-2)
2. Start playing back the device selected in step 1, and start
recording on the tape deck connected to TAPE-2.
NOTES:
@ When the TAPE-2 MONITOR is off, any source signals can be
monitored through the speakers or the headphones (this is nor-
mal operation).
e If tape deck 2 is 3-head type however, you can monitor the
recording directly of the tape by turning TAPE-2 MIONITOR
on. Refer to the tape deck instruction manuals for more details.
Set the recording level using the controls on the tape deck used
for recording.
—
see
1. Connect the graphic equalizer to the TAPE-2 jacks on the
rear panel.
2. If a second tape deck is used, connect it to the tape jacks on
the graphic equalizer.
3. Press the TAPE-2 MONITOR button to turn on the TAPE-
2 MONITOR indicator.
Follow the graphic equalizer operation instructions.
To record an equalized signal, use the tape deck (connect to the
equalizer) for recording.
Data can be recorded from video-disc players. video cassette recorders connected to VIDEO-2 and 3.
Connect the VCR to VIDEO-? and/or VIDEO-3.
Refer
to
each
instruction
manual
for
information
concerning
video-disc
players.
video
camcorders,
video
cassette
recorders
and
monitor
TV.
REC OUT
—<
SOURCE
REC OUT
COL
i FYacksltha> | SOURCE
cutee TndeS «'[owLe 2 Lvine> 3 ‘ape: [tare 2 [>unea i] pnono}| oo”
“cp
Ct SOUR ¥NEO! VIDED? ViDLO 2 CTAPE TAPE 2) TUNER "PHONG. |
a. Recording the source being played back.
1. Select the source to be recorded with the input selector
buttons.
Press the REC OUT button.
3. Press the REC OUT button again while the REC OUT
indicator is flashing.
The SOURCE and the source you have chosen will be dis-
played in red boxes. (*)
4. Start the source selected in step 1, and start recording on
the VCR connected to VIDEO-2 and/or VIDEO-3.
N
b. Recording a source different from the one being played back
.. Press the REC OUT button.
«. Press the input selector button of the source to be
recorded while the REC OUT indicator is flashing.
The chosen source will be displayed in a red box. (*)
‘s Start the source selected in step 2, and start recording on
the VCR connected to VIDEO-2 and/or VIDEO-3.