Onkyo TX-SV525

Listening
to
devices
connected
to
this
unit
in
another
room
Make sure that recording is not being carried out before performing the following operations.
The
following
steps
(except
step!)
can
be
performed
using
the
remote
control.
It
is
recommended
that
the
adjustments
described
below
be
done
in
the
main
room
in
advance,
since
it
is
not
possible
to
operate
the
remote
control
in
another
room
while
watching
the
display
of
the
TX-SV5
25/R.
Remote control
MULTI
SOURCE
INPUT SELECTOR
Co) CO
TUNER
Co
Remote control
C3 Co) COC)
VIDEO-1 VIDEO-2 VIDEO-3
Remote control
SPEAKERS
MAIN REMOTE
Co CO
SPEAKERS
MAIN REMOTE
NOTES:
30
The Surround mode becomes Bypass when the multi-source is used.
PHONO cD 4
1. Turn the MR OFF button off.
MR OFF indicator is turned off.
. Press the MULTI SOURCE button.
REC OUT > indicator will be turned off and the
MULTI SOURGE| indicator will flash for 8 seconds.
. While this is flashing, use the Input Selector button to select
the desired source.
If the tuner is selected with MULTI SOURCE and the Input
Selector is set to something other than TUNER, the tuners fre-
quency and group displays will be shown for 3 seconds.
When changing the source, be sure to press the MULTI
SOURCE button before pressing the Input Selector button.
Pressing the Input Selector button without first pressing the
MULTI SOURCE button will change the source in the main
room.
. Adjust the level using the MULTI SOURCE LEVEL A/
V buttons on the remote control.
MULTI and the level will be indicated on the display for three
seconds, the indication for the sub room output level ranges
from the minimum of (-- ce dB), —78, -77, ... -I, to the maxi-
mum of (0 dB). It is recommended that the level be set lower in
advance in the main room (to about —66 dB).
. Press the SPEAKERS REMOTE button to illuminate the
REMOTE indicator.
Press the MAIN button to turn off the MAIN indicator if you
are not listening to the sound in the main room.
The
source
indicated
by
the
Input
Selector
will
be
output
from
the
TAPE-!
and
2
REC
OUT,
and
VIDEO-2
and
3
OUT
terminals.
Pressing the REC OUT button will turn off the Remote speakers.
If the multi source is selected, MR OFF will automatically be deactivated.
If
the
multi
source
is
selected
for
REC
OUT,
or
the
SURROUND
MODE
button
is
pressed,
MR
OFF
will
automatically
be
activated.