Off, <=0.5", <=1.0", <=1.5", <=2.0", <=3.0", <=5.0", <=10", <=20", <=50",
<=100" [arc-seconds]
5.6.1.1.6 Coordinates
[You can enter arbitrary RA/Dec coordinates here (e.g. comet or asteroid coordinates
obtained from sources like a planetarium program)]
5.6.1.1.7 Spiral Search
[New as of version 3.02a. If your alignment is poor and a 'Goto' did not put the object
in the field of view or you want to browse around an extended object like M42 in a
spiral pattern, this function initiates a spiral search at the current guide rate around the
current position. Press any button to stop.]
5.6.1.1.8 Last
[New as of version 3.02d. If you didn't locate the object using the Spiral Search
function, perhaps because it was moving too slowly or too quickly, this option will
return to the last used 'Goto' coordinates where you could change the guide rate and
try again.]
5.6.1.1.9 Home
[Will prompt for confirmation of model clearance. Use N/S to toggle Yes and No
('Yes' clears the model and returns to the home position, 'No' aborts the Goto Home
command). If you do not want to lose the model because the telescope will not be
moved since the last alignment you should use the 'Park' function.]
5.6.1.2 Sync
['Stars', 'Deep Sky' and 'Solar System' will sync the telescope to the coordinates of the
object selected without moving the telescope. You are expected to have centered the
object already]
Stars
[Same selections as Goto, Stars]
Deep Sky
[Same selection as Goto, Deep Sky]
Solar System
[Same selection as Goto, Solar System]
Here
[syncs to the last Goto coordinates]
5.6.1.3 Align
1..9-Star Align
[e.g. '1-Star Align', '2-Star Align', '3-Star Align', etc.]
Show Model
[shows pointing model coefficients derived from the alignment points]
Clear Model
[clears the model]
17
To Next Page
Loading...
